Product Overview
The Rivertrace OCD Xtra Oil in Water Analyser is an advanced monitoring system designed to measure oil concentrations in water, even in challenging applications involving dark produced water and high levels of suspended solids.
Using multi-wavelength optical measurement technology and intelligent compensation algorithms, the OCD Xtra provides accurate oil measurements across a range of 0–200 ppm. The system supports factory calibration for up to six different oil types, with additional on-site calibration adjustments based on laboratory analysis.
The analyser features a multi-parameter display showing real-time oil concentration, sample pressure and historical measurement trends. Designed for marine, offshore and industrial applications, the OCD Xtra supports reliable water quality monitoring and environmental discharge management.
Key Features
- Accurate oil-in-water measurement from 0–200 ppm
- Factory calibration for up to six different oil types
- Multi-wavelength optical measurement technology
- Reliable monitoring of dark or contaminated water
- On-site calibration adjustments using laboratory results
- Real-time display of oil concentration and sample pressure
- Four-hour graphical measurement trends
- Seven-day measurement history
- Two adjustable oil concentration alarms
- Multiple analogue output options
- Configurable solutions for demanding industrial environments
Applications
- Produced water discharge monitoring
- Industrial wastewater discharge
- Hydrocarbon leak detection
- Deck drain discharge monitoring
- Cooling water monitoring
- Offshore oil and gas installations
Technical Specifications
Measurement Performance
- Oil measurement range: 0–200 ppm
- Resolution: 1 ppm / 1 NTU
- Accuracy: ±5 ppm up to 50 ppm; ±10% of reading above 50 ppm
- Factory calibration: Up to six oil types
- Clean water calibration: ±10 ppm from factory-set values
- Solids discrimination: Minimum 100 ppm for calibrated solid types
- Alarm setpoints: Two user-adjustable alarms, 1–200 ppm
Inputs & Outputs
- Alarm contacts: 2 single-pole relays, 8 A at 250 V AC
- Fault contact: 1 single-pole relay, 8 A at 250 V AC
- Analogue outputs: Isolated 0–20 mA, 4–20 mA or 0–5 V DC
- Remote input: Start/stop function via latching switch
Operating Conditions
- Ambient temperature: 0°C to +45°C
- Sample temperature: 0°C to +50°C
- Sample flow rate: 0.5–4 L/min
- Sample pressure: 3–10 bar
- Ambient humidity: Maximum 90% RH at 50°C
System Specifications
- Protection rating: IP65
- Supply voltage: 24 V AC, 115 V AC or 230 V AC
- Frequency: 50–60 Hz
- Power consumption: Maximum 60 VA
- Weight: Approximately 25 kg
- Standards: Tested to EN 61010 and EN 61326
Specifications subject to change without notice.